- 1). Disconnect the washer power cord. Slide the washer 1 to 2 ft. away from the wall.
- 2). Pry the brand emblem off the top of the front panel with the flat-blade screwdriver. Remove the screw that was under the emblem.
- 3). Pull the top panel forward one-half inch. Lift the front of the top panel up until it stays in the open position on its rear hinges.
- 4). Remove the four screws along the top of the front panel. Lift the front panel up to disengage it from the base. Set the front panel aside.
- 5). Unhook the water inlet hose in the left rear portion of the top of the tub.
- 6). Unsnap the locking tabs around the top edge of the tub. Lift the tub ring out.
- 7). Unhook the three tabs around the edge of the balance ring at the top of the tub with the flat-blade screwdriver. Lift the balance ring out of the washer.
- 8). Insert the tip of the flat-blade screwdriver into the notches at the base of the agitator dome. Pry the dome off and remove it.
- 9). Remove the six bolts holding the outer wash plate in place at the base of the tub. Lift the plate out of the Calypso washer.
- 10
Loosen the spanner nut holding the universal joint assembly in place at the base of the tub with the socket wrench. Remove the spanner nut. Lift the joint assembly out. - 11
Lift the tub straight up to remove it from the washer cabinet.
SHARE
