- Washing machine hoses are very similar to garden hoses, although much shorter. Each screw fitting connecting the water supply spigot to the Maytag washer has a rubber washer making a water-tight seal. If the leak is around the hose fittings, unscrew the hose and check the washers. Any wear or cracking means they require replacement. Also, if the hoses are more than five years old, replacing the entire unit is a good idea. Replacements are available at home supply stores, and each hose costs just a few dollars in 2010.
- The Maytag washer uses an electrically operated mixing valve to decide which water feed line to use: hot water, cold water or a little of both for warm water. If water is leaking around the mixing valve, replace the valve. The good news is this is not a difficult procedure. The valve assembly is connected to the two incoming hoses and one exiting to the tub. An electrical wire connects the valve to the Maytag washer controls. Using a screwdriver, remove the back panel from the washing machine, and remove the clamp holding the hose leading to the tub. Disconnect the wire, and unscrew the valve from the bracket. Replace with a new valve, available from appliance parts suppliers, in the reverse order you removed the old one.
- Check the hose leading to the tub for any cracks or bad fittings at both ends. Replace if necessary. Purchase the new hose very inexpensively from any auto supply store. Take the hose to the store, match the diameter and it can be cut to length from a rolled hose.
- Check the drain line on the back of the Maytag washer for a secure fit. It's held with a large pinch clamp to the washer drain and is goose necked into the sewer drain line. Make sure the connection is tight. You can purchase a Maytag part to replace a damaged hose or use a generic general purpose washing drain line of the same diameter. Usually buying generic will save money.
Hose Fitting
Mixing Valve
Tub Feed Line
Drain Line
SHARE
