- 1). Pull the top portion of the slideout assembly to extend it fully. Place the bottom of the base tube on top of the assembly so that the holes on the base match up with the holes on the assembly. Insert three of the included 1/4-20 nylock nuts into the holes and tighten them with the hex wrench. Insert two bushings into the top and bottom of the tube.
- 2). Insert two bushings into the top and bottom of the adapter support tube. Place the spacer onto the pin on the bottom of the swivel tube and insert this tube through the bottom of the assembly and through the base tube and the adapter support tube. Put the cap on top of the adapter support tube and rotate the swivel tube so the holes on both tubes line up. Insert two of the included 1/4-20-by-1/2-inch screws and tighten them.
- 3). Close the slideout assembly and place it in the center of the cabinet with the front handle flush with the front of the cabinet. Extend the slideout assembly once again and insert the six included 10-16-by-3/4-inch penta-pin screws into the six holes at the bottom of the assembly. Use the penta-pin tool to secure the base to the cabinet.
- 4). Place the adapter plate against the upper support tube so that the holes line up with the holes on the support tube. Insert the two included M5-by-10 mm socket pin security head screws into the holes and tighten them down. Attach the rubber bumper to the bottom of the base tube with one of the included M4-by-10 mm Phillips screw.
- 5). Place the back of the LCD screen in front of the adapter plate. Insert two M4-by-12 mm screws through the adapter plate assembly and into the holes on the back of the screen. Tighten them down securely.
SHARE
