- 1). Eject the magazine and rack the slide of the pistol to ensure that the firearm is not loaded. Once you verify that the chamber is clear, drop the slide and pull the trigger to release the striker.
- 2). Press down on the square button located below the striker button on the rear of the slide until you have depressed it approximately 1/8 to 1/4 of an inch.
- 3). Lift up the rear of the slide while keeping a thumb or finger over the striker above the square button. This prevents the firing pin spring from ejecting the striker retainer.
- 4). Remove your thumb from the striker retainer gently, then pull the slide forward and off the barrel.
- 5). Remove the firing pin spring, striker and retainer from the rear of the slide.
- 6). Pull the recoil spring forward off the front of the barrel.
- 7). Soak a .25-caliber bronze brush in carbon solvent and run it through the barrel a few times to loosen any carbon fouling.
- 8). Run a .25-caliber mop through the barrel to remove the carbon fouling loosened in step 7, then soak a cotton swab in carbon solvent and swab out any other fouling found on the remaining parts of the pistol. You can easily identify carbon fouling by the black stains left on the metal components.
- 9). Oil the pistol lightly using a light gun oil, then reassemble the pistol in the reverse order of steps 1 through 6.
Disassemble and Clean the Raven P25
SHARE