With Codes

• 1). Turn the television set on by pressing the "Power" button on the set.
  
  
• 2). Find the "Code Search" button on the Philips Magnavox remote. This button will be labeled or will be a different color than the other buttons on the remote (depending on which Philips Magnavox remote you own).
  
  
• 3). Hold the "Code Search" button down for about ten straight seconds. The light on the Philips Magnavox remote should then stay on.
  
  
• 4). Enter the three digit code for your Philips Magnavox remote. You will find this code in the user manual for your TV remote. The light on the remote should turn off after you've entered the correct code.
  
  
• 5). Press one of the channel buttons or the power button on the Philips Magnavox remote. If the TV changes color (or turns off if you pressed the power button), you have correctly programed the remote.
  
  

Without Codes

• 1). Repeat steps 1 to 3 above.
  
  
• 2). Starting pressing either the "Up" or "Down" channel button on the Philips Magnavox remote. Continue pressing the same button until the television responds to the remote. It could take a few minutes for the channel to change so you'll need to have patience when searching for the remote code in this manner.
  
  
• 3). Press the power button on the Philips Magnavox remote once the channel has changes. If the device shuts off, press the power button again to turn the TV back on. If the TV turns on, the remote has been programmed correctly. Repeat the entire process if your remote is not programmed.