- 1). Slide the two large clamp-straps through the slots on one side of the large L-shaped bracket.
- 2). Set the L-bracket in place on the outboard's exhaust tunnel so that the bracket wraps around the exhaust tunnel.
- 3). Slide the vinyl covers over the clamp-straps. Wrap the clamp straps around the outboard's exhaust tunnel.
- 4). Install the ends of the clamp-straps into the clamp's screw-in fittings. Tighten the screws with a screwdriver.
- 5). Install the clamp-straps in the small L-bracket. Fit the small bracket to the auxiliary outboard and install the vinyl covers over the clamp-straps. Fasten the clamp straps to the auxiliary outboard.
- 6). Push down on the female quick-connect fittings on the L-brackets and snap the male quick-connect fittings on the tie rod into the fittings on the L-brackets.
SHARE