- 1). Identify the Rinse Aid warning light on the display panel. It's pretty much right in the middle and is marked "Rinse Aid."
- 2). Check the light and add rinse aid if the light is illuminated. The dry cycle will not work properly if the rinse aid has run out. Rotate the round cap counterclockwise to remove it. Add to the maximum fill level.
- 3). Replace the rinse aid cap and turn clockwise.
- 4). Make sure the rinse aid adjustment lever is set to factory specified level 3. The setting is under the cap. Setting it too high will cause foaming. Too low will contribute to poor drying.
- 5). Check for a kinked drain hose if water remains in the tub. Clean out the air gap---it's on the sink---if the water isn't draining properly and run the waste disposal if your dishwasher drains into it.
- 6). Check the cycle has completed fully.
SHARE