- 1). Raise your camper awning to a comfortable working height. Set the ridge-support poles in place. Unroll the add-a-room tent with the vinyl wall facing outward.
- 2). Connect the front of the add-a-room tent to the middle ridge pole. Replace the middle ridge pole in the awning.
- 3). Start at one corner, and press the Velcro pieces together from the front wall of the tent to the support channel on the inside of the awning. Snap the front panel to the awning support bar.
- 4). Take out the ridge pole from the left side of the add-a-room tent. Put the upper end of the pole into the sleeve on the room panel. Fasten the attached straps to the pole. Replace the ridge pole in the awning and extend to desired height. Repeat for the right side of the tent.
- 5). Attach the side walls by pressing the Velcro pieces together onto the awning. Zip the side wall panels to the front tent panel. Fasten the attached straps to the awning legs.
- 6). Raise the camper and awning fully. Fasten the shock cord from the rail near the awning lift arms to the hook on the lower body panel flange.
- 7). Seal the add-a-room skirt to the curbside body panels by pressing the Velcro pieces together. Zip the skirt ends closed. Cover the wheel well, pressing the Velcro together on the flap.
- 8). Put the rear skirt flap facing outside the tent and the other skirts facing inward. Stake the skirt flaps down. Lock all poles into position.
SHARE
