- 1). Get a PVC T-connector that has a slightly larger inner diameter than your handlebars. Lay your T-connector on a tidy workspace with its bottom T facing you. This will form the top of your handlebar mount. Cut the T-connector in half with the rotary tool.
- 2). Drill a 1/4-inch hole into the PVC cap's center. Insert the carriage bolt into the hole.
- 3). Slide a flat washer and a lock washer onto the exposed threads of the bolt. Screw the two 1/4-inch nuts onto the bolt. Tighten the first nut but not the second. Screw the cap onto the T-connector.
- 4). Cut the rubber tubing. Use your T-connector as a size reference when cutting the tube. Cut a slit right across the tubing's length.
- 5). Slip the rubber tubing over the center part of the handlebars. Place the lower and upper halves of your T-connector around the rubber tubing.
- 6). Secure the T-connector in place or to your handlebars using your hose clamps. Tighten the hose clamps.
- 7). Mount the camera by screwing it onto the threaded end of the carriage bolt. Secure the second nut or bolt against the camera's bottom to prevent the mount from loosening.
SHARE
