- 1). Lay out your steel sheets, one on top of the other and drill four holes, one at each corner, that are large enough for your steel rods.
- 2). Have someone help you hold the top steel sheet while you attach the rods with washers and bolts. Put one washer and one bolt on the end of each rod's top and bottom. Take your soldering iron and melting metal and secure the bottom bolts by melting metal onto and around the bolts, both on the inside and outside. Do the same for the top sheets bolts. The frame of the cage should be secure enough to stand on its own now.
- 3). Drill 26 holes on the top and bottom of each sheet large enough for the steel wire to run through. Run the wire through the holes and with your soldering iron, weld the ends of the wire to the metal sheets on the top and the bottom.
- 4). Take your saw and cut a 10 by 10 inch square out of the middle of one side for a door. Save the pieces and set them aside.
- 5). Solder the edges of the cut wires along the steel molding so that it makes a 10 inch square opening with smooth edges.
- 6). Take the pieces of wire you cut away from the hole and cut an additional 1/4 inch off of them. Solder them to the remaining 4 pieces of steel molding so that it makes a framed door.
- 7). Solder the hinges onto the cage and door so that it swings freely without obstruction.
- 8). Solder the safety latch hook to the door of the cage. Then solder the safety latch catch to the cage opening.
- 9). Secure bowls and toys to the bars of the cage and add any other accessories you have purchased from the pet store before introducing the Grey to it's new cage.
SHARE
