- 1). Pull out the magazine holding the projectiles the airsoft gun fires from the compartment inside of the bottom of the handle, using your fingers.
- 2). Place an old pillow by itself against a wall. Cock the firing mechanism of the airsoft gun. Aim the airsoft gun at the pillow. Press the trigger to make sure there are no projectiles still in the airsoft gun.
- 3). Shake the barrel of the airsoft gun to dislodge any projectiles from it.
- 4). Hold the airsoft gun in your left hand (or your right hand, if you are a lefty). Locate the small gap at the back of the top of the airsoft gun that is just in front of the hammer--the hammer is at the very end at the back of the airsoft gun.
- 5). Insert the tip of a flat-edge screwdriver into the gap using your right hand. (Use your left hand if you are left-handed.)
- 6). Wiggle the tip of the flat-edge screwdriver back and forth to force the gap open. Stop wiggling the tip of the flat-edged screwdriver when the gap looks to be about an inch wide.
- 7). Reinsert the magazine into the bottom of the airsoft gun all the way until it stops. Aim the airsoft gun at the pillow. Press and hold down on the trigger to fire off your newly automatic airsoft gun.
SHARE
