- 1). Cut the roll of two -inch Scotch tape out of the package with scissors. Start the scissors at the end of the package and cut it to where the tape is located. Pull up on the packaging and remove the tape by hand.
- 2). Measure the width of the tape holder to make sure that it can accommodate the two-inch Scotch tape roll.
- 3). Set the Scotch tape into the opening on the holder. Bring it down from the top and set it between the two plastic circles on each side. The tape fits snugly between the small plastic bars and snaps into place on the inside of the holder.
- 4). Spin the tape back and forth in place, and pull the end of the tape off and toward the front of the holder. Set the end on the blade at the end of the holder. Push down on the tape and secure it in place on the blade.
- 5). Pull out the tape to the desired length, bring it down on the blade and push your thumb on the tape just past the blade. Break the piece of tape off.
SHARE