- 1). Turn off the Segway device and make sure that it is not plugged into the wall. Lay the machine down so the bottom of the device is exposed. Use a 3mm hex wrench to take out the screws holding in the battery panel on the bottom of the machine.
- 2). Take out the old battery from the chassis by pulling until it clicks out of place. Place the new battery into the chassis and push down until you hear it click into place. Make sure the curved edge of the battery pack is facing outside of the chassis.
- 3). Thread in four fasteners, either the M4x0.7x16 or M4x.07x30 sizes (the correct size will be included with the Segway when purchased), and torque them to either 1.0 Nm or 1.6 Nm, respectively, using the wrench.
SHARE
