Home & Garden Architecture

How to Install Stone Steps

    • 1). Decide what type of stone steps you want. The basic options are large natural stones as both treads and risers, or built-up steps formed with smaller rocks and installed with concrete or mortar. Use natural stones for a more rustic look, especially on gentler slopes where wider treads and lower risers work well. Build steps of quarried rock, usually cut into regular shapes like rectangles or squares, on steep slopes where a lot of short steps will be needed. Use quarried rock as an option on wider treads and gentler slopes.

    • 2). Lay out the step line and mark it on both sides with wood stakes and builder's twine, slightly larger than the planned final width. Dig out the area with a shovel, basically making steps in the ground with risers and treads spaced approximately the final height and width. Cover the dirt with landscape fabric to prevent weeds and grass from growing in the steps. Make a border of wood, metal or plastic at the desired width of the steps; this can be permanent or made to be removed when steps are finished.

    • 3). Put down a base of gravel, using boards across the step area to hold it in place until the stones are installed. Compact the gravel and level it. Add a layer of sand or wet concrete to make it easy to adjust the height of the steps to level them. Build steeper steps by setting risers in place first to hold the later treads; plan these so each riser will go to the bottom of the tread stone below, which will help hold it in place. Make individual stone steps by starting at the bottom, laying one stone in place, then overlapping the next stone slightly; work your way to the top of the steps. Remove the temporary retaining boards once stones are set.

    • 4). Add tread stones on steps with built-up risers. Use a level to make sure these are flat and level. Make sure there are no protrusions or upright chunks that can catch toes and trip people. Adjust the stones in the sand or wet cement to correct such problems; in extreme cases, use a hammer and cold chisel to chip off outcroppings.

SHARE
RELATED POSTS on "Home & Garden"
Types of Insulation for Your Home
Types of Insulation for Your Home
Building a Concrete Slab
Building a Concrete Slab
How to Install a Floating Hardwood Floor
How to Install a Floating Hardwood Floor
How to Stain Existing Cabinets
How to Stain Existing Cabinets
Information on Fiberglass Insulation
Information on Fiberglass Insulation
Definition of a Tar Kettle
Definition of a Tar Kettle
How to Prep Interior Door Panels for Paint
How to Prep Interior Door Panels for Paint
How to Install House Doors
How to Install House Doors
How to Remove Vinyl Self-Adhesive Tile From a Bathroom Wall
How to Remove Vinyl Self-Adhesive Tile From a Bathroom Wall
How to Remove a Magic Chef Refrigerator Freezer Wall
How to Remove a Magic Chef Refrigerator Freezer Wall
Facts on Landlords
Facts on Landlords
Different Custom House Plans
Different Custom House Plans
Basement Remodel Design Tools
Basement Remodel Design Tools
How to Finish an Existing Residential Concrete Floor
How to Finish an Existing Residential Concrete Floor
How To Build an Access Door
How To Build an Access Door
How to Make a Jig to Install a Cabinet Pull
How to Make a Jig to Install a Cabinet Pull
The Types of Hurricane Shutters & Awnings
The Types of Hurricane Shutters & Awnings
How to Care for Kempas Hardwood
How to Care for Kempas Hardwood
Attic Flooring Options
Attic Flooring Options
Types of Wood in Plywood
Types of Wood in Plywood
Roof Vent Options
Roof Vent Options
How to Build a Log Cabin From an Old Barn
How to Build a Log Cabin From an Old Barn

Leave Your Reply

*